The DLOG block on a Telepace based SCADAPack is a super useful function. However, it can sometimes fail. Monitoring the status code will allow you to see what the DLOG block is doing and suggest possible solutions to the problem. Code Description Solution 10 The configuration is valid and data can be logged. All fine. […]
Category: RTU Development

SCADAPack Memory Issues
We work with SCADAPack PLCs a lot in our line of work. They are pretty flexible devices. However, what many people do not know is that they have a relatively old OS and do not have great memory management. Here are my tips for properly setting up a SCADAPack. Some explanation as to why towards […]
Setting Up the Redigate 110e IoT Gateway for Modbus TCP
I took some time ‘off’ over the holidays in December to play with some of the new technology and equipment that is now available on the market place. Earlier this past fall I purchased a couple Redigate IoT Gateways from Elecsys. They are nifty units with support for over 60 protocols and the ability to […]
Basic Redigate Configuration
This is the first post in a series of posts regarding the setup of a Redigate IoT Gateway. I purchased a couple a few months ago and have finally gotten around to playing with them. Out of the box the Redigate is almost ready to go. If you follow the quick start documentation provided you […]

SCADAPack Store and Forward
Little known fact: SCADAPacks can act as a Modbus Store and Forward hub when configured properly. Lesser known fact: SCADAPacks will also Store and Forward Enron Modbus, ROC Protocol, or basically any communications protocol where the first byte of the message is the address, has messages less than 240 bytes and uses Modbus CRC for […]
BettsM SCADA Forum and Demo Day
I spent some time down in Calgary today with BettsM Controls checking out the various products they represent and sell. There are some interesting tidbits people might be interested in. Xetawave radios – These are software defined radios. One part number is good for 900Mhz, 400Mhz. They are able to stand in for a Freewave, […]

DNP3 Address Mapping on Standard SCADAPack
This month has been a great learning month. I was able to build and complete a small water SCADA system here in Canada (thanks GlobalFlow for the opportunity!) and we made the communications work using DNP3. So this system is built with SCADAPacks talking over a serial radio. Conveniently the master radio is at the […]

Fun with Red Lion DSP – Polling MC-IIIs
The Red Lion DSP is a great little unit. It has mostly the same internals as their G3 HMI line but without the display. This makes it useful as a protocol conversion box, a data collector or a simple web based remote monitoring unit using the built-in web server. BUT it has its quirks; it […]

Use a 4102 Multi-Variable Transmitter with a Floboss 107
The past few weeks have been incredibly busy. I cannot describe it. But I decided to make some time to try out something non-standard that might save clients some money on their transmitter costs. First off I need to give a shout out to Simark Controls for lending me this new 4102 transmitter so I […]
Setup ClearSCADA Ethernet DNP3 Communications to a SCADAPack (non-E series)
So before the weekend I posted and put up screenshots detailing how to get DNP3 configured on SCADAPack to report up to a ClearSCADA SCADA host server. What follows is the matching ClearSCADA configuration to complete the loop. These screenshots were taken with the latest ClearSCADA 2017, but should also work fine in older (back to […]